How to Make an Led Blink?
IN THE VEDIO THE PROJECT HAS BEEN DONE USING JUMPER WIRES .
LEts make some simple party lights with led’s 😀
How Does it Work?
Basically, LEDs are just tiny light bulbs that fit easily into an electrical circuit. But unlike ordinary incandescent bulbs, they don’t have a filament that will burn out, and they don’t get especially hot. They are illuminated solely by the movement of electrons in a semiconductor material, and they last just as long as a standard transistor. The lifespan of an LED surpasses the short life of an incandescent bulb by thousands of hours. Tiny LEDs are already replacing the tubes that light up LCD HDTVs to make dramatically thinner televisions.
What we Can Do With it?
>maKE LED BLINK
and lots more………….
>Arduino Uno (Buy From Amazon.in) (Buy From Amazon.com)
>AN ORDINARY LED (Buy it From Amazon.in)(Buy it From Amazon.com)
Lets Get Started
Connect Arduino According to the CIrcuit
> Digital pin 13- led positive leg
(do not use +5v or 3.3v pin without 300 ohm resistior , it can burn the led)
> Gnd -led negative leg
After following the above step. OPEN THE FILE WITH Arduino IDE.
aS SOON AS YOU UPLOAD YOU CAN SEE THE LED BLINK
yoU CAN ADJUST THE TIMMING BY CHANGING THE DELAY VALUE (delay(1000); –> —> —> delay(2000); )
tHATS ALL MAKERS FOR TODAY!
WE WILL BE COMMING WITH MORE INTRESTING PROJECT SOON!
If you have any doubts just comment it with the tag “#MM”
Stay Tuned for more Projects!